EVX-10 EX HEPA

The EX1 HEPA line. Its scope includes Class II, Groups E, F and G, and Group E is the conductive metal-dust group. The EV EX HEPA line is covered for Groups F and G only, so it does not carry Group E coverage — which matters directly in metalworking, aerospace, foundry and battery applications where the dust is frequently Group E. If you are specifying for aluminium, titanium, magnesium or other metal dust, ask us to confirm the line and scope against your area classification before ordering.

That depends on the line and on your area classification. The EX1 HEPA line is listed under explosion-proof and dust-ignition-proof enclosure standards. The EV EX HEPA line is listed as nonincendive equipment for Class II, Division 2 — it is not a Division 1 listing. Because Division 1 means the hazardous atmosphere is expected in normal operation, this distinction is not a technicality. Confirm the classification with your engineer and let us match the line to it.

No. Class I is Group D only — propane, methane and most common hydrocarbons and industrial solvents. Groups A, B and C cover acetylene, hydrogen and ethylene and are not within our listing. Note also that Class I coverage applies to the EX1 HEPA line only; the EV EX HEPA line has no Class I coverage at all, and is limited to Class II, Division 2, Groups F and G.

Not while keeping the unit in its certified configuration. The listing covers the vacuum together with PrestiVac-supplied hoses and tools, and static-dissipating hose and filters are required. Fitting a hose from general stores or a tool borrowed from another machine takes the unit outside the scope of its listing without anything visibly changing — which is why this tends to happen in service rather than at purchase.

Grounded and bonded in accordance with the National Electrical Code, Article 250. Static-dissipating hose and filters are part of the required configuration. The practical point is that the path has to be continuous from the tool through the hose to the container — a grounded machine with a non-conductive hose attached leaves the charge generated in the hose with nowhere to go, and the machine will keep working normally without anyone noticing.

It usually comes down to two things: your area classification and whether you have adequate compressed air at the point of use. An air-operated unit is driven by compressed air through a venturi, so there is no electric motor, no switch and no cord in the recovery unit at all — which removes the electrical ignition question from the drive entirely and suits long continuous running. Electric units suit facilities without sufficient plant air. Both are built with the same conductive, grounded and bonded recovery path, because the dust carries static regardless of what drives the machine. Air units are louder, which is worth planning for in occupied areas.

They are tested at different particle sizes and efficiencies. Standard HEPA is tested to a minimum of 99.97% efficiency at 0.3 micrometres; PrestiVac units are rated at 99.99% absolute, and factory H14 grades reach 99.995%. ULPA extends further, to 99.9995% at 0.12 micrometres. Which you need follows the requirement — the room classification, the exposure limit, or the sanitation standard — rather than a preference for the larger number. Ask what a filter is tested to rather than what it is called.

No. We manufacture industrial vacuums — explosion-proof, HEPA, air-operated, wet and dry, central systems and custom-built units. A dust collector is a different machine: high air volume at low suction, capturing dust at the source through fixed ducting. A vacuum is lower volume at high suction, removing what has already settled. Most dust programmes need both, and we would rather point you to a collection-system specialist for that half than sell you the wrong equipment.